Product Categories
Contact Us

Dr.c

TEL:+86-4000035601

Moblie:8615861891921

Email: info@dr-c.cn

Home > News > Content
Aesthetic Syringe And Solid Connector For Injection Precautions
Dr.c | Updated: Jul 12, 2017

Aesthetic Syringe And Solid Connector for injection precautions
Use a beautiful syringe and a solid connector to quickly select the injection volume and repeat the adjustment (conventional ± 5% error, skilled ± 1% of the error) When using a micro-beautiful syringe and a solid connector, Follow the advice below:
1. Operation coordination, so as soon as possible and accurate injection of the sample, after the pressure into the needle after the beautiful syringe and solid connector in the inlet should stay 2 seconds.
2. Hold the beautiful syringe and the solid connector as far as possible by the edge (surface or no scale), which prevents heat transfer when the syringe is held by the finger, and the beautiful syringe and the solid connector holder prevent heat transfer from the finger Easier puncture septum.
3. Touch the top of the needle bar with your fingers instead of the needle bar. This reduces the likelihood of damage and contamination.
4. For maximum accuracy, the injection volume is less than the maximum capacity of the beautiful syringe and the solid connector. When the injected sample contains a component with a high boiling point, fractionation may occur unless the Aesthetic Syringe And Solid Connector have Solvent plug (cut with air bubbles), with the sample into the injection port.
5. Wipe the inside of the syringe and the solid connector inner surface (needle or pin) with a sample of the needle bar by sampling the sample with a beautiful syringe and a solid connector to ensure accurate sampling.
6. Extract samples from the vials that exceed the amount of sample required, remove the beautiful syringe and the solid connector from the bottle, move the needle to the desired scale, discard the extra sample, do not use the beautiful syringe and the solid connector Head attached to the droplets.
7. Before the injection with no cotton fiber Sassafras clean injection needle, action fast, be careful not to beautiful syringes and solid connector sample aspirated, do not pass the body heat from the fingers to the needle.
8. Visual inspection of Aesthetic Syringe And Solid Connector within the bubble or foreign matter in the sample
9. Be careful when removing the needle syringe and the solid connector, because the needle has a dead volume, pressurize the vial with an airtight aesthetic syringe and a solid connector filled with an inert gas, and repeat this operation if necessary, In order to establish pressure in the bottle.
10. When using a sticky sample, use a thick needle. Do not use blunt or damaged needles, and 5 do not tighten the septum nut too tight, otherwise the septum life will be shortened, because the high temperature can also shorten the life of the septum, it is recommended to use a heat sink nut to keep the low temperature , Aesthetic Syringe And Solid Connector All septum will eventually leak, every day for a septum is to prevent leakage of good measures, analysis of the task for a long time to be more frequent replacement, some septum can last 150 injections, but before the best regular replacement.

Feedback
Dr.c
If you have any enquiry about quotation or cooperation, please feel free to email us at info@dr-c.cn or use the following enquiry form. Our sales representative will contact you within 24 hours. Thank you for your interest in our products.
Copyright © Dr.c All rights reserved.